How do I update my Structure Sensor (ST01)'s firmware?

Firmware updates are simple.

Just open the Structure app, and click on the gear icon in the lower right-hand corner of the screen. If a firmware update is available, you'll see a message that lets you know.

This is a picture of Winnie-The-Pooh in greyscale next to the firmware status shown by clicking the gear icon mentioned above.

Click on the "update firmware" button, and your Structure Sensor will automatically begin and complete the firmware update process.

If for any reason you run into an issue feel free to email us:

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.