How to incorporate support for original Structure Sensor into your app with SDK 3.1


The Structure Sensor 1 uses a different communication protocol than the Structure Sensors 2 and 3. This is temporary - Structure is working on an update so that all sensors will use the same communication protocol.


However, if it's imperative that all three sensors are supported by the same app today, you may wish to add a switch to your app to enable Structure Sensor 1 Compatibility mode (Beta only).


Structure Scanner currently features a Structure Sensor 1  compatibility mode switch, and the changes implemented to support this switch are documented on this link.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.