Getting Started - Attaching Your Sensor to the Compression Bracket

Step 1. Attach bracket to Sensor

Use the screws provided with your Structure Sensor (Mark II) or Structure Sensor Pro to attach the sensor to the bracket. Note: be sure not to overtighten.



Step 2. Attach bracket to iPad

Position bracket as shown. Slide bracket onto iPad slowly by pushing down. Make sure the bracket is seated against the iPad edges.



Glass Screen Protectors

Please note: Glass screen protectors on iPads will interfere with the fit of the bracket as our brackets are measured precisely to fit to the iPad. Please ensure you remove any glass screen protectors before you try to install the bracket onto your iPad.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.